Licensed, insured, and trusted across Montgomery County since 2012.

Flat Roof Repair in conroe That Stops Leaks for Good

Flat Roof Repair in conroe means finding the actual failure point, not just patching over it. We handle TPO, EPDM, and modified bitumen systems on homes and commercial buildings across Montgomery County. If water is ponding or a ceiling stain just appeared, we get out there, diagnose it, and fix it before the next storm rolls through.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

Call Now (936) 305-7093 → No spam. No obligation. Just practical help.
Conroe Shield Roofing serving conroe, Texas
Careful work. Honest options.
About this service

What Flat Roof Repair in conroe Actually Involves

Flat Roof Repair in conroe is the process of diagnosing and correcting failures on low-slope roofing systems, including membrane punctures, seam separation, flashing failures, and drainage problems. Most flat roofs here are TPO, EPDM, or modified bitumen. Each one fails differently. TPO seams can pull apart after thermal cycling. EPDM shrinks and pulls at the edges. Modified bitumen cracks as it ages. We identify the material first, then match the repair method to how that specific system fails.

Conroe sits in a climate that swings from 100-degree summers to freezing nights in January. That expansion and contraction cycle is brutal on low-slope roofs. We see ponding water after heavy spring rains, UV degradation on south-facing membranes, and flashing failures around HVAC curbs. If you have been searching for flat roof leak repair in conroe, Texas, the problem is usually at a seam or penetration, not the field of the roof. Finding it fast saves you from ceiling damage and mold.

  • ✓ Same-Day Emergency Response
  • ✓ Material-Matched Repairs
  • ✓ Moisture Detection Technology
  • ✓ Workmanship Warranty
What's included

What Our Flat Roof Repair Service Includes

Every flat roof repair is different, but here is what you can expect as part of the standard service. If something is not covered, we tell you upfront before any work begins.

✓

Full Roof Inspection

We walk the entire roof, not just the area above the leak. Flat roofs often have multiple problem spots. We check seams, flashing, drains, penetrations, and membrane condition. You get photos of everything we find.

✓

Moisture Mapping

Infrared camera and moisture meter readings show us where water is trapped under the membrane. This tells us if the deck is wet and how far the damage spreads. Without this step, repairs are guesswork.

✓

Membrane Repair or Replacement

We repair TPO, EPDM, and modified bitumen membranes using material-matched patches and sealants. If a section is too far gone, we replace it and blend it into the existing roof.

✓

Flashing and Seam Sealing

Most flat roof leaks start at flashing or seams. We reseal every edge, curb, and penetration in the repair area. We use roof sealant and roof cement rated for Texas heat.

✓

Drain and Scupper Clearing

Clogged drains cause ponding, and ponding kills flat roofs. We clear drains, scuppers, and downspouts as part of the repair. If drainage is inadequate, we tell you what it takes to fix it.

✓

Cleanup and Final Test

We clean up all debris and materials when we are done. Then we water-test the repair area and check moisture readings again. You get a walkthrough and your warranty paperwork before we leave.

How it works

How Our Flat Roof Repair Process Works

01

Call and Schedule

You call (936) 305-7093 or book online. We ask what you are seeing, where the water is showing up inside, and how old the roof is. Most Conroe-area inspections get scheduled within 24 to 48 hours. If it is an active leak, we prioritize you same-day.

02

On-Site Inspection

A HAAG Certified Inspector walks the roof, checks seams, flashing, drains, and penetrations. We use a moisture meter and infrared camera to map wet areas under the membrane. You get photos of every problem area and a written scope before we leave.

03

Repair Plan and Pricing

We explain what failed, why it failed, and what it takes to fix it. You get a flat price, not an hourly estimate. Most repairs fall between $350 and $1,800 depending on scope. If the roof is beyond repair, we tell you that too and price a replacement.

04

Repair Day

We show up when we say we will. The crew protects landscaping, sets up safely with harnesses and ladders, and completes most repairs in 2 to 6 hours. We clean the membrane, apply the patch or coating, and seal every edge. You get progress photos if you are not home.

05

Final Test and Walkthrough

We water-test the repair area and check for any remaining moisture with the meter. You get a walkthrough of what we did, photos of the finished work, and your warranty paperwork. If you have questions two months later, call us. We answer.

Tools & methods

Tools and Methods We Use for Flat Roof Repair

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Infrared Camera

Detects moisture trapped under the membrane by reading temperature differences. Finds wet areas that are invisible to the naked eye.

Moisture Meter

Confirms moisture readings in the membrane and deck. We use it before, during, and after repairs to verify the fix.

Roofing Nail Gun

Fastens base sheets and insulation boards when we replace sections of the roof system. Pneumatic for speed and consistency.

Caulking Gun

Applies roof sealant and roof cement to flashing, seams, and penetrations. We use high-quality sealants rated for Texas heat.

Utility Knife

Cuts TPO, EPDM, and modified bitumen membrane cleanly for patches and repairs. Sharp blades make clean edges that seal better.

Pry Bar

Removes old flashing, edge metal, and failed sealant without damaging the surrounding roof. Essential for flashing repairs.

Safety Harness and Ladder

Keeps our crew safe on every roof. We follow OSHA 10 and 30 safety standards on every job site.

Real results

Before and after.

TPO Roof Leak Repair in April Sound

Before

A homeowner in April Sound had a ceiling stain that kept growing after every rain. The TPO membrane had a failed seam near the HVAC unit. Water was running along a joist and dripping 10 feet away from the actual leak.

After

We cleaned the seam, applied primer and sealant, and installed a cover strip. The leak stopped immediately. We also checked every other seam on the roof and found two more that were starting to fail. We repaired those too.

Commercial Flat Roof Repair in Downtown Conroe

Before

A commercial building owner had ponding water on a modified bitumen roof. The drains were clogged with debris, and water had been sitting for days. The membrane was blistered and cracked in several spots.

After

We cleared the drains and scuppers, repaired the blistered sections, and applied a reflective roof coating over the entire roof. Water now drains within hours of a storm. The coating also lowered the building's cooling costs.

Emergency Flat Roof Repair in River Plantation

Before

A storm tore the edge of an EPDM membrane loose on a home in River Plantation. Water was pouring into the sunroom. The homeowner called us at 7 a.m. during an active storm.

After

We arrived by 10 a.m., tarped the area to stop the water, and returned two days later to make the permanent repair. We re-secured the membrane edge, replaced the flashing, and sealed it. The sunroom is dry.

Problems we solve

Flat Roof Problems We Solve for Conroe Property Owners

These are the most common flat roof issues we see in Conroe. If you are dealing with any of these, call us before the damage gets worse.

Ask a pro →
01

Water ponding on the roof after rain

We find why water is ponding, whether it is a clogged drain, a sagging deck, or poor original pitch. We clear drains, repair low spots, and re-pitch small areas so water flows off the roof within 24 hours of a storm.

↗
02

Ceiling stains and active drips inside

We trace the leak back to its source, which is often not directly above the stain. We repair the membrane or flashing, dry out the area, and give you documentation for your insurance if the damage is storm-related.

↗
03

Seam separation on TPO or EPDM roofs

We clean the seam, apply the correct primer and sealant, and use a roller to press the membrane back together. For badly failed seams, we install a cover strip or patch over the area.

↗
04

Flashing failures around HVAC units and vents

We remove the old flashing, clean the area, and install new flashing with proper sealant and fasteners. We check every penetration in the area, not just the one that is leaking.

↗
Proof you can check

Licensed, Certified, and Trusted in Conroe

✓
HAAG Certified InspectorHAAG Engineering
✓
OSHA 10 CertificationOccupational Safety and Health Administration
✓
OSHA 30 CertificationOccupational Safety and Health Administration
✓
NRCA MemberNational Roofing Contractors Association
✓
Texas Roofing LicenseState of Texas
Customer reviews

What Conroe Customers Say About Our Flat Roof Repair

★★★★★
“We had a leak over our garage for months. Two other companies just patched it and it kept coming back. Conroe Shield found the actual problem, which was a failed seam near the HVAC unit. They fixed it in one afternoon and we have not had a drop since. That was last spring.”
MT

Marcus T.Homeowner, Downtown Conroe

✓ Verified
★★★★★
“After the last big storm, water was pouring into our sunroom. I called at 7 a.m. and they had a crew out by 10 a.m. to tarp it. They came back two days later and did the permanent repair. Professional, fast, and no surprise charges. Highly recommend.”
DK

David K.Homeowner, River Plantation

✓ Verified
Good questions

Frequently Asked Questions About Flat Roof Repair

(936) 305-7093 →

Most flat roof repairs in Conroe run $350 to $1,800 depending on the size and complexity. A simple seam repair might be $350 to $600. A larger section with flashing and drain work could hit $1,200 to $1,800. Emergency tarping is usually $250 to $500. We give you a fixed price before we start, so you know exactly what you are paying.

Ponding happens when the roof was not pitched correctly during installation, when the membrane has sagged over time, or when drains and scuppers are clogged. In Conroe, heavy spring rains expose poor drainage fast. Standing water for more than 48 hours breaks down TPO and EPDM. We can re-pitch small areas or clear and repair drains to get water moving again.

Conroe Shield Roofing has been repairing flat roofs in Conroe since 2012. We handle TPO, EPDM, and modified bitumen systems for homes and commercial buildings. Call (936) 305-7093 and we will schedule an inspection, usually within 24 to 48 hours. For active leaks, we offer emergency flat roof repair conroe TX service with same-day response.

Most flat roofs can be repaired if the damage is localized and the deck is still sound. If more than 30% of the membrane is failing or the deck has soft spots, replacement makes more sense. We inspect with a moisture meter and infrared camera to check the deck. You get an honest answer, not an upsell.

Ready when you are

Get Your Flat Roof Repair in conroe Scheduled Today

Water damage gets worse every day you wait. We offer same-day emergency service for active leaks and free inspections for non-emergency repairs. Call (936) 305-7093 and we will get you on the schedule.

Schedule Inspection (936) 305-7093 →
Request an appointment

Contact Conroe Shield Roofing

Call us at (936) 305-7093 or email info@conroeshieldroofing.com and we will get you scheduled. We answer 24/7 for emergencies and return non-urgent calls the same business day. Free estimates across Conroe and Montgomery County.

Tap to call(936) 305-7093